SUPERMICRO PWS-1K22A-1R 800W/1200W Redundant Single Output Power Supply
Brand: SUPERMICRO Part No.: PWS-1K22A-1R
$23.00
In stock (4 units), ready to be shipped
Price-matching available. If you find this item for a lower price, let us know.
Our Warranty
Core 4 Solutions provides a standard 30-day hardware warranty on parts and components and a 90-day hardware warranty on complete systems and switches, unless a different term is expressly stated on your quote, invoice, or online order confirmation. Coverage up to one year is available at no additional charge on approved purchases. Extended coverage beyond one year is available for an additional fee.
Description
The Supermicro PWS-1K22A-1R is a 1U hot-swap redundant power supply rated 800W on low-line input and 1200W on high-line input, with a single +12V output and 80 PLUS Titanium efficiency. It plugs into the power backplane of Supermicro 1U servers through a gold finger card edge connector, so no output cables are involved.
At a glance
- 800W at 100-127Vac, 1200W at 200-240Vac
- 80 PLUS Titanium, 96% efficiency
- 1U hot-swap redundant, single +12V output
- Refurbished, tested twice, 1-year advanced replacement warranty
Outfitting a Supermicro 1U server?
Tell a Core 4 sales engineer which system you are working on. Beyond a matched pair of power supplies, we can supply the fans, rails, drives, memory, and other components that server needs. Talk to a sales engineer or call 1-855-55-CORE4.
Technical specifications
| Output power | 800W (100-127Vac) / 1200W (200-240Vac) |
|---|---|
| Output | Single +12V: 66.7A / 100A |
| Efficiency | 80 PLUS Titanium, 96% |
| Form factor | 1U, hot-swap, redundant |
| Input voltage | 100-127Vac / 200-240Vac |
| Input frequency | 50-60Hz |
| Output connector | Gold finger (card edge to system backplane) |
| Power factor correction | Active PFC |
| Management | PMBus 1.2 |
| Protection | Over-voltage, over-current, short-circuit |
Compatibility
Supermicro validates the PWS-1K22A-1R for 1U servers including the AS-1124US-TNRP and SYS-1029U-TN12RV. The module slides into the server's power supply bay and connects to the backplane by its card edge, with no +5V, +3.3V, or separate 8-pin or 4-pin 12V connectors.
In a redundant pair, run two PWS-1K22A-1R units side by side rather than mixing models. Full 1200W output requires 200-240Vac input; on 100-127Vac circuits each supply is limited to 800W, which matters when sizing a server with high-TDP CPUs or GPUs.
Fits these systems:
- AS-1124US-TNRP
- SYS-1029U-TN12RV
Condition
This PWS-1K22A-1R is refurbished: a fully functioning power supply, typically decommissioned from a working production environment or drawn from overstock, returns, or off-lease equipment. The vast majority of these units were never broken or repaired.
Core 4 tests every supply when it arrives and again before it ships, and any unit that does not pass is repaired before it is sold. Because these supplies have already been installed and burned in, early failures are weeded out, and Core 4 sees a lower dead-on-arrival rate than with new units straight from the factory.
It is covered by Core 4's 1-year advanced replacement warranty: if the supply fails within a year, a replacement ships right away, before the failed unit comes back.
Datasheets and documentation
- Supermicro PWS-1K22A-1R 800/1200W 1U 80 Plus Titanium Redundant Power Supply
- PWS-1K22A-1R 800W/1200W 1U Redundant Power Supply Specification
Common questions
Will the PWS-1K22A-1R deliver 1200W on a 120V circuit? No. On 100-127Vac input it is rated 800W (66.7A on +12V). The 1200W rating (100A on +12V) applies on 200-240Vac input.
Can it be replaced while the server is running? Yes. It is a hot-swap redundant module, so in a server running two supplies one can be pulled and replaced while the other carries the load, provided the remaining supply can handle the system's draw.
Can the supply be monitored remotely? It supports PMBus 1.2, which lets the server's management controller read power and status data. A front LED also shows normal or abnormal operation.
Does it come with power cables or output leads? It has no output cables. Power is delivered through a gold finger card edge connector into the server's power backplane. An AC input cord for the supply's inlet is a separate item.
Specifications
- Condition
- Refurbished
- Brand
- SUPERMICRO
- Part No.
- PWS-1K22A-1R
- Weight
- 6.0 lb